During the normal use of the floor washing machine, due to the aging of machine parts or incorrect operation, the machine may have major or minor malfunctions. Mastering some simple fault handling methods can prevent the cleaning effect and efficiency of the floor washing machine from being affected by some small reasons. Therefore, it is necessary for the operator to briefly understand the troubleshooting methods of common faults of the floor washing machine.

1. The floor washing machine does not produce water, or the water volume is small.

1. Confirm whether the water outlet switch is turned on. If not, you need to turn on the water outlet switch.

2. Check whether the water volume in the clean water tank is sufficient. If the water volume in the clean water tank is insufficient, clean water needs to be injected.

3. Check whether the water outlet pipe is blocked. If so, the water outlet pipe needs to be cleaned.

4. Check whether the clean water tank ball valve is damaged. If it is damaged, replace the clean water tank ball valve of the floor washing machine.

2. The floor washing machine does not absorb water, or the water absorption effect becomes poor.

1. Check whether the sewage tank is properly covered. Failure to cover it tightly will affect the suction power.

2. Check whether the squeegee rubber strip is close to the ground. If the rubber strip is excessively worn, replace it with a new one. Or during the cleaning process, some solid garbage blocks the rubber, which reduces the water absorption effect. At this time, you only need to lift the water absorber and put it down.

3. Check the suction pipe to see if there is any foreign matter blocking the pipe.

3. Check whether the sewage tank is full. If the sewage tank is full, the sewage needs to be discharged.

Three: The brush plate of the floor washing machine cannot rotate.

1. Check whether the power of the floor washing machine is sufficient. If the power is insufficient, charge it in time.

2. Check whether the fuse is blown and whether the carbon brushes of the brush plate motor are severely worn.

If you encounter any of the above faults that are not caused by these, you should call the after-sales service phone number in time and ask the floor washing machine manufacturer or local service provider to come and perform maintenance work.