Online shopping has become more and more fashionable, and now everything, large and small, can be purchased online. Floor washing machines are no exception. Many friends who have never used a floor washing machine do not know how to install and use a floor washing machine after buying it online. They are very confused. Next, let the editor of YOUNISI introduce the installation process of a hand push floor washing machine. Let’s analyze the main components of a hand push floor washing machine and what their functions are.

After we first get the hand push floor scrubber, we will find that in addition to the main unit, there are also the YOUNISI hand push floor scrubber brush tray, needle plate, charger, squeegee, key, certificate, manual, etc., and then there is the battery of the floor scrubber, because the floor scrubbers on the market are basically battery-driven floor scrubbers, and the wire-type hand push floor scrubbers have basically been eliminated.

Well, let’s take a look at how these accessories of the hand push floor washing machine are installed on the hand push floor washing machine and how these parts are used:

The batteries of the walk-behind floor scrubber are basically two pieces. Each battery of the walk-behind floor scrubber is connected in series with 12V. Remember, it must be connected in series. There are basically obvious signs on the battery, black and red. Black is the negative pole, red is the positive pole. The battery of the push-type floor scrubber is usually under the sewage tank of the machine. Find where there is a switch and open the sewage tank. You can basically see the place where the battery of the push-type floor scrubber is placed. After connecting it and turning on the key, the push-type floor scrubber can basically run normally.

The brush disk is obviously one of the main functions of the floor washing machine. The brush disk of the floor washing machine is installed at the front end of the floor washing machine. Basically, you can see at a glance that the brush disks of the hand push floor washing machine are designed at the front end of the machine. The brush disk lift switch of the hand push floor washing machine is basically Basically, the pedal mode is used at the last side of the machine, where people stand. Use your feet to lift the brush tray cover and insert the brush tray under the brush tray cover. Align it. Remember to align it and try to place it in the center of the brush tray cover. Go back to the back of the machine and lower the brush tray cover with your foot.

The squeegee is the main water-absorbing part of the hand-push floor scrubber. It is basically installed at the rear of the floor scrubber through two screws, which is the bottom of the place where people push it. After finding it, you can basically align and tighten the screws. The installation of the squeegee is relatively simple.

Going back to the top of the machine, the main control part of the hand push floor scrubber is basically at the hand push position. It is relatively simple. Basically, there will be a display screen. After turning the key on, you can see the battery level and the working time. There are also the brush plate working switch and the squeegee working switch. The most important thing is the key switch.

Then there is the water injection port of the hand push floor washer. Just add water after you find it.

According to the above steps, the installation is basically completed. The next step is to operate. Turn on the key switch, put down the squeegee and brush tray, press the water suction button and brush tray button, hold the machine forward, and the machine will run normally. In fact, in general, the installation of a floor scrubber is very simple. Just install the battery, squeegee and brush tray and follow the correct method. It's the same as our battery car, so if you buy it, don't be anxious, take a look at the video or manual first. Another thing is that YOUNISI now provides on-site training, so on-site learning is OK! !