After the YOUNISI floor scrubber is used for a period of time, the rubber strips will wear due to friction, which will affect the water absorption effect. Therefore, please check the condition of the rubber strips frequently. Nowadays, the water-absorbent strips of many floor scrubbers can be used on all sides. What are the differences in the replacement steps of this kind of water-absorbent strips? How should they be replaced? Please see the specific steps below:

Water-absorbent strips can be used on all sides of the floor scrubber. Replacement steps:

1. Use the squeegee lifting handle to lower the squeegee;

2. Loosen the two fixed handles and remove the squeegee from the bracket;

3. Remove the suction pipe from the squeegee;

4. Loosen the fixing buckle;

5. Take out the adhesive strip;

6. The adhesive strip can be used repeatedly on all four sides. If all four sides have been used, replace it with a new one;

7. Reinstall the fixed bracket;

8. Fasten the fixing buckle to complete the replacement of the rubber strip.

Things to note

The angle between the rubber strip and the ground is kept at approximately 45°, which results in better water absorption.

Adjust the angle of the squeegee by correcting the nut. The angle of tightening the nut increases and the angle of tightening the nut decreases.

During the floor washing process of the YOUNISI floor washing machine, the water-absorbing adhesive strips are shaken at a certain frequency according to the ground conditions, and the small sand particles and other garbage adsorbed on the adhesive strips are shaken off, so as not to affect the water absorption effect.

Although the above steps may seem troublesome, the actual replacement is very simple. If you have more questions about YOUNISI floor washing machine accessories, please visit the official website of YOUNISI: http://www.china-leader.com/.