The fully automatic floor washing machine is a fully automatic cleaning equipment that integrates spraying, washing and sewage recovery. Fully automatic floor washing machines are divided into driving floor washing machines and hand push floor washing machines according to their walking methods. Apart from their different walking methods, these two types of equipment have mostly the same working principles, common accessories and usage precautions.

The fully automatic floor washer is equipped with multiple rotating brushes or scouring pads, which are used with clean water or detergent-added washing liquid to clean the floor through mechanical friction. The rear of the floor washer is equipped with a squeegee to recycle sewage into the sewage tank through vacuum suction.

Commonly used models of fully automatic floor scrubbers The detergent used in fully automatic floor scrubbers must be alkaline and low-foaming, because too much foam will damage the water-absorbing motor of the floor scrubber. If the floor to be cleaned is very dirty, it is recommended to pre-wash it first. Pre-washing means raising the squeegee first, turning off the suction motor, and scrubbing the floor repeatedly. When the scrubbing is almost done, turn on the suction motor and lower the squeegee to suck up the sewage on the floor while scrubbing.

1. Read the manual of the floor washing machine carefully before use and use it safely after training. Generally, when the machine is delivered, dedicated after-sales service personnel will provide on-site training to those who will use the floor washing machine on precautions and usage methods.

2. Please do not operate the machine before it is fully assembled. Users should carefully check the integrity of the machine before operating it.

3. In the area that needs to be cleaned, preliminary cleaning should be carried out first, mainly targeting some large non-water-soluble particles, such as small stones, and other garbage that will affect the work of the squeegee. The reason is that the squeegee must form a closed space with the ground to recycle sewage, otherwise it will not be closed and cannot work properly. This is of great benefit to you in improving work efficiency and protecting the machine.

4. For particularly dirty floors, you can choose to wash them repeatedly without absorbing water first, and then absorb water separately; or choose different detergents to improve the cleaning effect of floor scrubbing.

5. Due to uneven ground, sometimes even after cleaning, if there is still water, you can raise the brush plate, start the water suction switch, push the floor washer, and absorb the water repeatedly and many times in the water area.

6. There are deep grooves on the ground, which will affect the water absorption efficiency of the machine. Please handle it as appropriate according to the situation at that time.

7. When the brush disk is in the ascending position, do not start the brush disk motor at will, otherwise the brush disk will be automatically removed.

8. Work after daily operation:

1. Wipe the outside of the floor washing machine clean with a dry or wet cloth, and check whether the filter sponge is blocked by water or dirt. If so, please take out the sponge, clean it, dry it before putting it back in;

2. Empty the sewage in the sewage tank, then add clean water to clean it. If it is particularly dirty, you can remove the sewage tank and clean it;

3. Raise the brush tray and squeegee, and park or charge the floor washer in a dry, ventilated, and flat environment free from flammable gases, liquids, chemicals, and open flames;

4. If it is stopped for a long time, the sewage tank and clean water tank should be cleaned and dried with the covers opened (the battery should be removed for battery-type floor washing machines), and the floor washing machine should be covered with a dust-proof cloth for storage.

The above are the precautions for daily use of Yangzhou fully automatic floor washing machine. Before using a fully automatic floor washing machine, you should check whether the drain valve is open, check whether the water volume in the clean water tank is sufficient, check whether the filter is blocked, check whether the water supply pipe is blocked, and check the wear of the brushes. Although it takes a long time, the cleaning effect is guaranteed, and the fully automatic floor washing machine can be maintained and maintained without damage.